Nut runner (U-Ribs Runner ) medium 22
Electric wrench for torque control tightening for M22 corresponding to a section.
I answer to tightening at the small part which can’t be used with a standard machine because it’s short with length 145mm.
It’s most suitable for an assembly part of the U rib part in a bridge and the truss part.
It’s possible to control the positive backspin identical torque value of amount accuracy .
High power M20 and M22
Is Manufacturer’s Suggested Retail Price in Japanese market as just for reference.
|Models||Max. torque (Nm)||Minimum torque capacity (N m)||The upper limit torque capacity (N m)||Idle speed (min-1[rpm])||repeated accuracy (%)||Single-phase voltage (V)||Max. current (A)||Max. power consumption (W)||frequency (Hz)||The Suitable bolt size||Controller||weight (g)|
|UR221T||735||370||735||14||± 5.||100||13.5||1,100||50-60||High power A hexagon bolt :M20 and M22||The outside bill torque controller||5300|
|UR222T||735||370||735||14||± 5.||200||6.5||1,100||50-60||High power A hexagon bolt :M20 and M22||The outside bill torque controller||5300|
- ※ A socket and a cable line aren’t included in Main body mass .
- ※ repeated accuracy is the one which expressed ill-balance of tightening torque which goes out to the time of a tightening outrigger by the same torque setting and work condition in the %.
|(22UR36T) for bar socket M22||1|
|The outside bill torque controller||1|
|Connector (only 200V)||1|
※ bar socket for M20 (22UR32T) is an option.
Precautions for use
- Torque control range fluctuates by the situation of bolt nut and the tightening target part.
- It isn’t possible to load Digitorqon on this product.